Crash Data Retrieval Accessories |
CDR (Crash Data Retrieval) Repowering RigTM
Our products are used in every state in the U.S., all Canadian Provinces as well as in Australia, Germany, the Grand Cayman Islands, and Korea.
This is the same CDR Repowering Rig that was previously offered, for over 10 years, with a purchase of the Bosch CDR Tool from Crash Data Group.
If you are interested in purchasing a Bosch CDR Tool, please visit www.crashdatagroup.com
Each CDR Repowering Rig kit includes a set of four fuse block adaptors which will fit Micro2, Mini, Micro3 and ATO automotive fuse sockets.
|
The use of a the CDR repowering rig allows you to provide a source of power directly to a vehicles airbag control module (ACM). This is of value when a vehicles electrical system has been compromised. Alternatively, the ignition may be damaged or there might not be an ignition key available.
The CDR deluxe repowering rig has a fused 12-volt plug and approximately 6’ of each wire. The positive wire has inline fuse protection as well and connects to the appropriate size fuse block adaptor. The fuse block adaptor takes the place of the vehicles airbag control module fuse. The negative wire has an alligator clip for connecting to your vehicle ground. The deluxe model has a built-in 12 volt receptacle, thus eliminating the need for a Y-adaptor when also powering the CDR Interface Module. You must supply your own 12-volt source of power for the CDR repowering rig and CDR Interface Module (when applicable).
Note: You must supply your own 12-volt source of power.
|
Do not use the add to cart button unless the item is being shipped somewhere in the United States or Canada.
For International orders please contact us via email us (using the form at the bottom of the page) as shipping will need to be calculated on a case-by-case basis.
The item will include a set of basic instructions. NO technical support or further instructions will be provided.
|
 |
CDR Deluxe Repowering Rig |
|
|
|
|